Thermostat water heater WTD14KG 14 liters/minute natural gas energy efficiency class A/L

The new range of HydroPower-Plus thermostatic heaters are even more ecological. This is the first range of thermostatic heaters with hydrogen ignition, which allows temperature preselection without the need for plugs or batteries. The exact temperature, as the HydroPower-Plus are thermostatic, they allow hot water to come out exactly at the temperature selected by the user.

Temperature regulation can be carried out degree by degree between 35ºC and 60ºC. The selected hot water temperature is displayed on the display.The exact temperature,New hydraulic block with integrated hydrogenerator,Capacities of 14 liters/min,Ignition by hydrogenerator,Thermostatic temperature control,Compatible with the solar range,Available for natural gas and butane/propane, LCD display with temperature and clock indication.

Description:

Heater with a medium consumption profile, with a capacity of 14 liters.

As it is thermostatic, the water temperature comes out at the exact temperature chosen.

It works with both natural gas and butane gas.

The installation of this heater is indoors.

The pilot only lights up when hot water is used, which makes energy savings superior.

Ignited by hydrogen generator without the need for plugs or batteries.

It has a security system based on temperature limitation. This prevents the outlet temperature of the domestic water from being too high, and in this way there will no longer be problems with the installation of pipes (it works with any type) and this function can be activated once the setup is done easily. and fast.

With ionization, that is, direct ignition on the burner. This allows the heater to start up quickly, so that the water reaches the user sooner, achieving greater water savings and lower gas consumption thanks to the complete elimination of the use of the ignition pilot.

Natural draft heater, that is, it does not require an additional ventilation system to evacuate combustion gases.

It has an AGU probe for burned gases. It is a security system to achieve a safer evacuation. According to the regulations, it must be guaranteed that there is no escape of the combustion products produced inside the heater. For this reason, this model detects if there is any type of failure or anomaly and immediately interrupts operation to avoid possible serious incidents.

It consists of an NTC temperature probe for DHW (Domestic Hot Water) and heating. The NTC (Negative Temperature Coefficient) probe – negative temperature coefficient, will decrease when the boiler temperature increases.

Temperature regulation can be carried out degree by degree between 35ºC to 60ºC.

It contains an LCD display with temperature indicator and clock.

The dimensions of the heater are: 65.5 cm high x 35 cm wide x 22 cm deep.

The gas evacuation outlet is 13 cm in diameter.

Technical characteristics:

ERP Class: A.

Installation: Indoor.

Ignition type: Electronic.

Power: 6-23.6 kW.

Minimum operating pressure: 0.25 bar.

Flow rate: 2.5-14 l/min.